Dec 29, 2015 - 5 min - Uploaded by iNTELLIGENT TECHNOLOGY TRADEiNTELLIGENT TECHNOLOGY TRADE ap1131ag-a-k9. View and Download Cisco 1130AG - Aironet - Wireless Access Point hardware installation manual online. Mercury Download there. Hardware Installation Guide. 1130AG - Aironet. Cisco Ap1142n Manual. Taking Business Mobility Mainstream. The Cisco ® Aironet ® 1140 Series Access Point is a business-ready, 802.11n access point designed for simple deployment and. View and Download Cisco 1130AG - Aironet - Wireless Access Point hardware installation manual online. Hardware Installation. Manual for AIR-AP1142N-T-K9, AIR-LAP1142N-T-K9, AIR-LAP1141N-A-K9, AIR-AP1141N-K9, made by Cisco Systems, Inc. (Cisco Systems, Inc.).
It's been a while since I've had to do this but, you can console to the device correct? Just no fancy web gui? Either way, I don't believe you need it, you can simply: Goto Cisco's site and under wireless, AP, 1200, IOS Software pull down the full version that you need, latest is c1200-k9w7-tar.123-8.JEE - NOTE: k9w7 is the full version, k9w8 is the Lightweight option. You should be able to drop a TFTP server onto your network (i use my laptop a lot for this) then set the IP address of that TFTP server to something in 10.0.0.2-30 range and rename the file as stated, so c1200-k9w7-tar.default Then, reboot the AP while holding mode and it will kick it off into recovery mode.
The AP will then pull the image from your TFTP server and then boot from there. Ipod A1320 Itunes Software Free Download there. When it's done, set an IP and you should be good to go. The LAP access points are designed to pull their configuration from a central controller.
Do you have a cisco controller running in the environment? If so, they should pull directly from that TFTP server. If not, you will need to convert it to a standalone AP.
See the article below with instruction on how to, you will need to focus on the section 'Converting a Lightweight AP back to Autonomus Mode' Note: You will most likely need a Cisco account to download the required tools/Image. If you don't have one, I'd work with the vendor who sold you the AP to get access to convert them. It's been a while since I've had to do this but, you can console to the device correct? Just no fancy web gui? Either way, I don't believe you need it, you can simply: Goto Cisco's site and under wireless, AP, 1200, IOS Software pull down the full version that you need, latest is c1200-k9w7-tar.123-8.JEE - NOTE: k9w7 is the full version, k9w8 is the Lightweight option. You should be able to drop a TFTP server onto your network (i use my laptop a lot for this) then set the IP address of that TFTP server to something in 10.0.0.2-30 range and rename the file as stated, so c1200-k9w7-tar.default Then, reboot the AP while holding mode and it will kick it off into recovery mode.
The AP will then pull the image from your TFTP server and then boot from there. When it's done, set an IP and you should be good to go.